|
ABOVE (clockwise from top): Pulp in blender, oven-dried
castings on cookie stamps (with handles) and on craft stamps (flat), dry
castings removed from stamps and ready to varnish, more stamps, bowl with fork
and pulp to spread on stamps, sponge to remove excess water.
What you'll need to make paper castings:
- Rycraft’s
100% cotton linter paper* – our linter paper is a very pure white in color
and
is made of natural 100% cotton fiber. No wood products are used.
- 1 or more
Rycraft cookie stamps or craft stamps
- Blender
(optional)
- Cooking oil
& toothbrush for oiling stamps
- Absorbent towels (cloth or paper)
- Water
- Felt or
sponge for blotting excess moisture
- Cookie
sheet
- Oven
preheated to 275 degrees
Optional: Scissors to trim around design, varnish, paints and brushes,
and other craft supplies of your choice to enhance your handcast creations
* You may use any paper you have on hand to make paper
castings
Five Easy Steps
1. Prepare the
pulp: Tear 1/4 sheet of linter paper
into small pieces (the size of a quarter or half-dollar), and put in blender.
Add 2 cups water, and allow to soak 1 minute. Blend at low speed for 1 minute
to make a soft, mushy pulp. Do not overblend. Pour pulp into a small bowl for
safe and easy handling. Note: You may want to drain excess water using a sieve.

2. Oil the
stamp: With a toothbrush, apply a thin
coat of oil to the surface of your stamp. Be sure to work oil into all the
indentations of the design. Wash excess oil off the stamp with soap and hot
water, and then rinse and towel dry. (See Molding Hints under Helpful Hints).

3. Fill the
stamp and remove excess water: For small
medallions, hold the stamp with the design face up over the bowl of pulp. Using
about one Tbsp. at a time, press the pulp gently onto the face of the stamp
until it is evenly covered, to about 1/8" thick.

Using a
piece of felt to cover the pulp on the surface of the stamp, press hard to blot
out excess water; then use your fingertips to work the pulp down into the
design. The harder you press, the smoother and more detailed the medallion’s
surface will be. Carefully turn the pulp and stamp face down onto a dry towel,
pressing firmly to remove as much water as possible.

For large
medallions, follow the instructions for small medallions. Then place a piece of
felt on a layer of toweling. On the felt, build up a thin layer of pulp that is
wider than the stamp. Turn your stamp (filled with pulp) face down, and press
firmly onto the layer of pulp you have built up. Use your fingers to apply
pressure to the stamp and the pulp around the stamp to remove excess water.

4. Oven dry the
pulp: For small medallions, remove the
felt, and set it aside. Place the stamp and pulp face up on the cookie sheet
for drying. For large medallions, carefully remove the felt, and place the
stamp and pulp face down on the cookie sheet.

Put the
cookie sheet in a 275° oven until the pulp is dry — 10 to 60 minutes, depending
on the thickness of the pulp. Medallions may also be dried in the sun on a warm
day. For faster drying, place stamps in a microwave on medium for 2 to 3
minutes; drying time depends on the individual microwave and the thickness of
the pulp
5. Remove the
paper medallion: When the paper is
completely dry and the stamp has cooled enough to touch, carefully lift the
medallion from the stamp.

Techniques for Special Effects
Special effects:
Experiment with adding food coloring and/or colored paper and/or
ultrafine glitter to small amounts of the wet pulp for special effects.
Molding hints: If
your casting sticks to the stamp, it needs more drying time, or you need to
clean and oil the stamp again as in Step 2. (Note: Step 2 need only be repeated
if your medallions are dry and still sticking to the stamps.)
Trimming and cutting:
If you plan to cut out the design of your medallion, use a small,
sharp-pointed pair of scissors, and make the layer of pulp very thin for easier
trimming. For crisp, clean edges, coat the medallion with decoupage finish or
acrylic varnish, let dry, and then cut to the desired shape.

Recycle leftover pulp and scraps: Save your scraps and trimmings of linter
paper, and add them to your next batch of pulp. Remember not to mix scraps that
have color or glitter with white pulp unless you intend to create a special
effect
Painting with texture:
If you want a grainy texture on your project, mix a little sand or tiny
grain (such as ground oatmeal or sawdust) with a little paint or glue.
Painted and Cut-out Medallions: Choose the stamp designs you like best. Use
the crisp, white medallions as they come off the stamp, or trim them into
cut-outs with scissors. use paint and glitter to decorate them (we recommend
adult supervision when children use glitter). You can also glue a magnet on the
back of cut-outs for a charming gift
How to Stiffen Doilies:
If your doily is unstarched, saturate it with spray starch or a
commercial fabric stiffener, and block as follows: (1) put wax paper on top of a board (styrofoam,
corrugated cardboard, or cork), and tape it down; (2) use pins to shape the wet
doilies and secure them on the board. Optional: After they are dry and stiff,
make them permanently stiff by applying a coat of varnish and let dry
How to Apply Glitter:
Two methods for applying glitter*
Method 1: Add fine
glitter to your paint (using an acrylic gel medium if you like), or add it to
varnish and brush it on. Let dry.
Method 2: Coat the casting with varnish and/or paint. Let it
dry. Then apply a coat of varnish or paint (only to the areas of the casting
where you want glitter), and sprinkle the glitter onto the wet varnish. Let
dry.
In both methods, you may want to add a sealer coat of
varnish to hold the glitter on the surface
*Ultra-fine and fine glitters are not recommended for
children.
–– BACK TO TOP ––
Creative Paper Casting Project Ideas
CREATE GIFTS & KEEPSAKES that your family and friends
will treasure: earrings, bookmarks, picture frames, barrettes, gift bags,
napkin rings, decorative boxes, and much more!
 #420 Holly Sprig,
#031 Noel Stocking, #001 - Santa Claus, #252
Gingerbread Boy
Ornaments and decorations:
To make unique holiday gift wrap, ornaments, and decorations, try
placing the medallion on a background piece such as a paper doily, a crocheted
doily treated with fabric stiffener, a contrasting piece of paper, or a piece
of fabric. Add a touch of paint and some ribbon here and there. To hang your
Christmas tree ornaments, use a decorative thread, ribbon or clear fishing
line.


Design shown above: #220
Rocking Horse
Projects for kids:
Spend a pleasant afternoon with your children baking cookies and making
beautiful papercast creations. Both preschool and school age children find
paper casting fun and easy. Give them some paint, glitter and ribbon to create
gifts they will be proud to give to family and friends.
Designs shown above (clockwise from top center): #014 Apple , #158 Prancing Pig, #201 Lacy Heart, #057
Butterfly, #061 Fuchsia Heart, #239 Garden Bouquet, #221 Sweethearts, #130
Daffodil, #037 Duck with a Bow, #237 Three Tulips, #061 Fuchsia Heart, #240
Leaf Blossom, #014 Apple, #191 Teddy Bear, #041 Jack Rabbit
Stationery and note cards:
To create beautiful and unusual stationery, glue a medallion onto a
piece of writing paper or note card. You can add a favorite phrase, poem or
birthday greeting to the paper prior to gluing on the medallion.

Designs shown above: #080 Wedding Bells, #274 Birthday Cake
–– BACK TO TOP ––
|